![]() ![]() Specify the direction of connection as 'From: Server' and 'To: A Virtual Machine'. Give the name to the Socket exactly the same one as you set it for the DEBUGGER, in this case - '/tmp/com1'. In virtual machine settings hardware tab click 'Add.' to add new 'Serial port' device.Set Serial port type to 'Output to socket'. Once you click 'Finish' the DEBUGGER VM is prepared to use the serial connection.Ĭonfigure the DEBUGGEE VM (the one which will be debugged). Also, make sure the device status is selected as 'Connect at power on' unless you require otherwise. ![]() Since the DEBUGGER will connect to a DEBUGGEE specify the direction of connection as 'From: Client' and 'To: A Virtual Machine'. I chose a '/tmp' folder and give the name 'com1', so that the full path of the socket is '/tmp/com1'. Give the name to the Socket (named pipe) a one you desire in a writeable location. Set Serial port type to 'Output to socket'. In virtual machine settings hardware tab click 'Add.' to add new 'Serial port' device. Start with the DEBUGGER VM (the one from where you will be connecting to the DEBUGGEE to perform kernel debugging). The approach is split into three parts - the VM hardware settings, MS Windows configuration, and establishing a debugging session. This is a step-by-step approach, excluding the actual host system installation, VMware setup and Virtual Machine creation, since these are rudimentary steps and anyone willing to perform kernel debugging should be capable doing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |